Ryzen 3 1200 OC Help

[kYuKi]

Motherboard: A320M PRO-VH PLUS
I've been able to get it to go past 3.47GHz to 3.6GHz on the vcore set to auto(I'm not going to attempt to go any further). My current RAM configuration is set to 3200 (just previously upgraded to two 8gb sticks). I'm wondering if it has something to do with BIOS or something, but I've been at a complete loss on how to proceed.

My stock speed is at 3.1 GHz with 3.4 turbo. With +1 from the auto vcore that is set to default I'm able to get it to 3.475. At 3.5 GHz it fails to boot with any voltage, even the standard 1.35 that I've read most Ryzen 3 1200 chips should be able to post with. What's funny is that I had set a previous OC profile on the board that had been able to boot, reloading it after increasing the voltage from that same OC profile it didn't boot. My current BIOS is from 2018 and I'm wondering if flashing the bios to a new version may help me. Any helpful ideas/hints is much appreciated and if you need anymore information I'll be happy to oblige.

 

[DeerFat]

I wouldn't recommend overclocking on A320 motherboards because they aren't rated for it. It's an entry level AM4 chipset and you could run into VRM-related thermal throttling.

 

[kYuKi]

I wouldn't recommend overclocking on A320 motherboards because they aren't rated for it. It's an entry level AM4 chipset and you could run into VRM-related thermal throttling.

Well, so far I haven't even hit past 55c's accross the board on anything even at 3.6Ghz, but I believe because of the voltage issue it's not going past 3.475Ghz. I've ran stress test and the vcore never goes above 1.24. Monitoring software never shows it going above the base clock. Only times I've seen it register 3.6Ghz is in Task Manager and Cinebench.

 

[Meyers]

Do not use auto vcore! That's just going to undervolt you or overvolt you. The included curves are terrible

 

[kYuKi]

Do not use auto vcore! That's just going to undervolt you or overvolt you. The included curves are terrible

Any ideas why it wont post past 1.27? The min is 1.104 and the max is 1.24 during test. Are these curves fine?

Edit: None of my OC profiles that posted with their voltages are posting now (well below 1.27).