Setting Hammer for Insurgency

[Cpt. Hopi]

This is not a question but a solution on how I did it.! So far it works setting it up so I want all of you to know.

First load Source SDK found in your Tools section. Make sure you engine version at the bottom says: Half-Life: 2 Episode 1. You can load on any game so start hammer up!

Now at the top of hammer click tools->Options.

You should be at game configuration tab. Next to configuration you'll see a button that says edit. Click it and hit Add then put in Insurgency.

Now for all the tabs please look at the picture and review it.

Now the last step click on the Build Programs tab and look at the picture again.

After so hit apply and ok then restart hammer/source sdk and under hl2ep1 you will see the game Insurgency. Click it and there you go. If you have any questions post in this thread or pm me.

*edit*
If an admin can maybe sticky this if it works please!

 

[HitmanX]

It started well, looks good. However it hit a problem, when I compiled a test.


** Executing...
** Command: Copy File
** Parameters: "C:\Program Files\Steam\steamapps\*********\insurgency\insurgency\maps\test.bsp" "\test.bsp"

The command failed. Windows reported the error:
"The system cannot find the file specified."

 

[Cpt. Hopi]

hmmm that error ive had it before in other games as well, honestly i have no clue on why it does it so sorry :|

 

[HitmanX]

So could you compile your Insurgency maps? If so then I've probably made a mistake in the setup somewhere.

The map that caused the error was very simple. An INS spawn point in a hollowed out box.

 

[Cpt. Hopi]

Umm I haven't compiled so give me a sec I will do so very soon.